3
Figure 1 Airflow through the MSR3012/3024 chassis
Figure 2 Airflow through the MSR3044/3064 chassis
To ensure good ventilation, the following requirements must be met:
The air inlet and outlet vents are not blocked, and leave at least 10 cm (3.94 in) of clearance.
The installation site has a good cooling system.
ESD prevention
To prevent electrostatic discharge (ESD), follow these guidelines:
Make sure the router and the floor are well grounded.
Take dust-proof measures for the equipment room.
Maintain the humidity and temperature at a proper level.
Always wear an ESD-preventive wrist strap and ESD-preventive cloth when touching a circuit board
or transceiver module.
An MSR3000 router does not supply an ESD-preventive wrist wrap. Prepare an ESD-preventive
wrist wrap yourself.
To Next Page
Loading...
