HP MSR4080

376
Figure 108 Network diagram
Table 28 Interface and IPv6 address assignment
Device
Interface
IPv6 address
Device
Interface
IPv6 address
Router A GE1/0/1 1001::1/64 Router D GE1/0/1 4001::1/64
Router A GE1/0/2 1002::1/64 Router D GE1/0/2 5001::1/64
Router B GE1/0/1 2001::1/64 Router D GE1/0/3 3001::2/64
Router B GE1/0/2 1002::2/64 Source 1 — 1001::2/64
Router B GE1/0/3 2002::1/64 Source 2 — 5001::2/64
Router C GE1/0/1 2002::2/64 Receiver 1 — 2001::2/64
Router C GE1/0/2 3001::1/64 Receiver 2 — 4001::2/64
Router C Loop0 6001::1/128
Configuration procedure
1. Assign an IPv6 address and prefix length to each interface, as shown in Figure 108. (Details not
shown.)
2. Configure OSPFv3 on the routers in the IPv6 BIDIR-PIM domain. (Details not shown.)
3. Enable IPv6 multicast routing, IPv6 PIM-SM, IPv6 BIDIR-PIM, and MLD:
# On Router A, enable IPv6 multicast routing, enable IPv6 PIM-SM on each interface, and
enable IPv6 BIDIR-PIM.
<RouterA> system-view
[RouterA] ipv6 multicast routing
[RouterA-mrib6] quit
[RouterA] interface gigabitethernet 1/0/1
[RouterA-GigabitEthernet1/0/1] ipv6 pim sm
[RouterA-GigabitEthernet1/0/1] quit
[RouterA] interface gigabitethernet 1/0/2
[RouterA-GigabitEthernet1/0/2] ipv6 pim sm
[RouterA-GigabitEthernet1/0/2] quit
[RouterA] ipv6 pim
[RouterA-pim6] bidir-pim enable
IPv6 BIDIR-PIM
Source 1 Source 2
Host A
Receiver 1
Router A
GE1/0/2
GE1/0/2
GE1/0/3 GE1/0/1
GE1/0/2
GE1/0/3
GE1/0/1
GE1/0/1
GE1/0/1
GE1/0/2
Router D
Router C
Router B
Host B
Receiver 2
Loop0