HP MSR4080

61
[Spoke1]interface tunnel 1 mode advpn gre
[Spoke1-Tunnel1]ip address 192.168.0.3 24
[Spoke1-Tunnel1]ospf network-type p2mp
[Spoke1-Tunnel1]source gigabitethernet 1/0/1
[Spoke1-Tunnel1]vam client Spoke1
[Spoke1-Tunnel1]quit
# On Spoke 2, configure GRE-mode IPv4 ADVPN tunnel interface tunnel1.
[Spoke2]interface tunnel 1 mode advpn gre
[Spoke2-Tunnel1]ip address 192.168.0.4 24
[Spoke2-Tunnel1]ospf network-type p2mp
[Spoke2-Tunnel1]source gigabitethernet 1/0/1
[Spoke2-Tunnel1]vam client Spoke2
[Spoke2-Tunnel1]quit
3. Configure OSPF:
# On Hub 1, configure OSPF.
<Hub1>system-view
[Hub1]ospf
[Hub1-ospf-1]area 0.0.0.0
[Hub1-ospf-1-area-0.0.0.0]network 10.1.1.0 0.0.0.255
[Hub1-ospf-1-area-0.0.0.0]network 1.1.1.1 0.0.0.255
[Hub1-ospf-1-area-0.0.0.0]network 192.168.0.0 0.0.0.255
[Hub1-ospf-1-area-0.0.0.0]quit
[Hub1-ospf-1]quit
# On Hub 2, configure OSPF.
<Hub2>system-view
[Hub2]ospf
[Hub2-ospf-1]area 0.0.0.0
[Hub2-ospf-1-area-0.0.0.0]network 2.2.2.2 0.0.0.255
[Hub2-ospf-1-area-0.0.0.0]network 192.168.0.0 0.0.0.255
[Hub2-ospf-1-area-0.0.0.0]quit
[Hub2-ospf-1]quit
# On Spoke 1, configure OSPF.
<Spoke1>system-view
[Spoke1]ospf
[Spoke1-ospf-1]area 0.0.0.0
[Spoke1-ospf-1-area-0.0.0.0]network 192.168.0.0 0.0.0.255
[Spoke1-ospf-1-area-0.0.0.0]network 20.1.1.0 0.0.0.255
[Spoke1-ospf-1-area-0.0.0.0]quit
[Spoke1-ospf-1]quit
# On Spoke 2, configure OSPF.
<Spoke2>system-view
[Spoke2]ospf
[Spoke2-ospf-1]area 0.0.0.0
[Spoke2-ospf-1-area-0.0.0.0]network 192.168.0.0 0.0.0.255
[Spoke2-ospf-1-area-0.0.0.0]quit
[Spoke2-ospf-1]quit
4. Configure IP multicast:
a. Configure Hub 1