HP MSR4080

62
# Enable IP multicast routing.
<Hub1>system-view
[Hub1]multicast routing
[Hub1-mrib]quit
# Enable PIM-SM on Loopback 0 and GigabitEthernet 1/0/2.
[Hub1]interface loopback 0
[Hub1-LoopBack0]pim sm
[Hub1-LoopBack0]quit
[Hub1]interface gigabitethernet 1/0/2
[Hub1-GigabitEthernet1/0/2]pim sm
[Hub1-GigabitEthernet1/0/2]quit
# Enable PIM-SM and NBMA mode on tunnel interface tunnel1.
[Hub1]interface tunnel 1
[Hub1-Tunnel1]pim sm
[Hub1-Tunnel1]pim nbma-mode
[Hub1-Tunnel1]quit
# Configure Loopback 0 as a C-BSR and a C-RP.
<Hub1>system-view
[Hub1]pim
[Hub1-pim]c-bsr 1.1.1.1
[Hub1-pim]c-rp 1.1.1.1
[Hub1-pim]quit
b. Configure Hub 2:
# Enable IP multicast routing.
<Hub2>system-view
[Hub2]multicast routing
[Hub2-mrib] quit
# Enable PIM-SM on Loopback 0.
[Hub2]interface loopback 0
[Hub2-LoopBack0]pim sm
[Hub2-LoopBack0]quit
# Enable PIM-SM and NBMA mode on tunnel interface tunnel1.
[Hub2]interface tunnel 1
[Hub2-Tunnel1]pim sm
[Hub2-Tunnel1]pim nbma-mode
[Hub2-Tunnel1]quit
# Configure Loopback 0 as a C-BSR and a C-RP.
<Hub2>system-view
[Hub2]pim
[Hub2-pim]c-bsr 2.2.2.2
[Hub2-pim]c-rp 2.2.2.2
[Hub2-pim]quit
c. Configure Spoke 1:
# Enable IP multicast routing.
<Spoke1>system-view
[Spoke1]multicast routing
[Spoke1-mrib]quit