Commands and Responses
HP NonStop TMF Management Programming Manual—540140-008
5-103
INFO AUDITTRAIL
ZAuditDump
specifies whether audit dumping is performed for the audit trail. The following
values are possible:
ZOverflowThreshold
specifies the percentage of active audit-trail capacity above which TMF begins
overflow copying.
ZBeginTransDisable
specifies the percentage of active audit-trail capacity that can be consumed
before new transactions are disabled.
ZMaxRetainedATFiles
specifies the maximum number of restored audit-trail files to retain on disk in
the RestoreVols for the specified audit trail after the restored audit-trail files are
no longer being used by a recovery process. The minimum value is 0, the
maximum 9999.
ZFileSize32
specifies the size of the audit-trail file, in megabytes. For the RVU covered by
this manual and all subsequent RVUs, ZFileSize32 always contains the correct
audit-trail file size.
ZCommitHoldMode
specifies the current state of the commit-hold attribute for the specified audit
trail. The following values are valid:
ZSPI-VAL-True Audit dumping is performed
ZSPI-VAL-False Audit dumping is not performed
ZTMF-VAL-ZLTCH-UnSupported Commit-hold mode is not
supported by the specified audit
trail.
ZTMF-VAL-ZLTCH-UnConfigured Commit-hold mode is not yet
configured for the specified audit
trail.
ZTMF-VAL-ZLTCH-On Commit-hold mode is on for the
specified audit trail.
ZTMF-VAL-ZLTCH-Off Commit-hold mode is off for the
specified audit trail.
To Next Page
Loading...
