HP Officejet g85 User Manual

Connect office equipment (optional)
This diagram shows a possible configuration for
connecting additional office equipment.
For each piece of office equipment you are connecting
to the HP OfficeJet, remove a plastic tab from the
phone/fax connector.
If you connect a modem, turn off its fax-receive
feature. See your Onscreen Guide for information on
tone versus pulse dialing and features such as
distinctive ring or voice mail.
7
Load paper
2
a
b
c
Make sure the Automatic
Document Feeder cord is
securely connected to the
unit.
Check
connection
here
4
Secure the cord
8
Remove the tray
from the carton.
Rest the box on its side
and pull out your HP
OfficeJet. Remove any
packaging or tape from
the HP OfficeJet.
Verify that you have
these additional key
components.
print
cartridges
Remove the print
cartridges from the
sides of the HP
OfficeJet.
1
Unpack your HP OfficeJet
a
d
b c
Connect the cable
Connect the USB cable
from your HP OfficeJet to
your Macintosh.
3
Connect the power
supply and the adapter.
5
Connect the power cord
HP OfficeJet G85 Quick Setup Poster
Macintosh Side 1 of 2
http://www.hp.com/go/all-in-one
power
print
cartridges
power cord
USB cable
(must purchase
separately)
1
3
2
phone cord
Open the
door and
raise it up
until it clicks
into place.
The print-
cartridge
carriage will
move to the
middle the
access area.
of
Lower the right print-cartridge
latch down onto the top of the
cartridge, and push down until
the latch locks firmly into place.
Remove the black print cartridge (thinner
one) from its packaging and, being careful to
touch only the black plastic, gently remove
both the green pull tab and the blue tape
covering the nozzles.
Push the black print cartridge firmly
down into the slot on the right. As
you insert the cartridge, make sure
the label is facing you.
Insert black print cartridge
9
CAUTION:
Do not touch
or remove
the gold-
colored
contacts.
a
db c e
Raise both latches on the
print carriage.
Connect the phone/fax cord to the
HP OfficeJet and then to the wall
6
Connect the phone cord
Note:
The instructions for this poster
ONLY apply to Macintosh
operating systems.
A high-speed USB cable (12
Mbps) no longer than five
meters must be purchased
separately.
HP OfficeJet
Installation
CD
Turn on your HP OfficeJet
*C6737-90121*
*C6737-90121*
C6737-90121
Turn
over to
continue.

HP Officejet g85 Specifications

General

Brand	HP
Model	Officejet g85
Category	All in One Printer
Language	English

Summary

Unpack Your HP OfficeJet

Remove Tray and Cartridges

Remove the tray from the carton and the print cartridges from the HP OfficeJet.

Unpack HP OfficeJet Unit

Rest the box on its side and pull out your HP OfficeJet, removing packaging or tape.

Verify Key Components

Confirm you have the power cord, phone cord, USB cable, and installation CD.

Load Paper

Connect the Cable

Connect USB Cable to Macintosh

Connect the USB cable from your HP OfficeJet to your Macintosh.

Secure the Cord

Ensure ADF Cord Connection

Make sure the Automatic Document Feeder cord is securely connected to the unit.

Connect the Power Cord

Connect Power Supply and Adapter

Connect the power supply and the adapter securely to the unit.

Connect the Phone Cord

Connect Phone/Fax Line

Connect the phone/fax cord to the HP OfficeJet and then to the wall.

Connect Office Equipment (Optional)

Configure Additional Office Equipment

Connect other office equipment via phone/fax connectors, removing plastic tabs as needed.

Turn On Your HP OfficeJet

Insert Black Print Cartridge

Prepare and Insert Black Cartridge

Open door, raise carriage, remove protective tabs, and insert black cartridge.

Insert Color Print Cartridge

Prepare and Insert Color Cartridge

Remove protective tabs and insert color cartridge into the left slot.

Print an Alignment Page

Perform Cartridge Alignment

Press ENTER to align cartridges and check the printed alignment page.

Install the Software

Run HP OfficeJet Installation

Insert CD, select language, accept agreement, and click Install for setup.

Select Country and Language (Outside U.S.)

Configure Region and Language Settings

Enter country and language codes on the keypad as prompted by the display.

Congratulations