3. Lift the latch handle on the print carriage.
4. Remove the printhead by lifting it up and then pulling it out of the printer.
5. Make sure the latch handle is raised, and then reinsert the printhead.
6. Carefully lower the latch handle.
NOTE: Make sure you lower the latch handle before reinserting the ink
cartridges. Leaving the latch handle raised can result in incorrectly seated ink
cartridges and problems printing. The latch must remain down in order to correctly
install the ink cartridges.
7. Close the ink cartridge access door.
Chapter 9
154 Solve a problem
To Next Page
Loading...