HP OMEN X 27 User Manual

15
IMPORTANT:
• Repair Condition: Connector repair is only for out of warranty.
• Repairing must operate by professional repairers (Note) in repair center, not
applicable for end user.
• Electrostatic protection is required when component replacement is required.
• The monitor meets ROHS, please use Lead-free solder wire for soldering.
• If Connector need to replace, must check specification and part number whether
match the BOM and location.
• If connector need to replace, please insert new parts carefully because the near
pin may cause short circuit by inappropriate operate.
• DO NOT allow any liquid on the board. Water and moisture may cause short-
circuit to the electronic components and lead to malfunctions.
• The fusion point of Lead-Free solder is requested. Repairing with conventional
lead wire may cause damage.
• Work quickly to avoid overheating the circuit board as soon as you confirm the
steady soldering condition.
• Keep the soldering iron tip clean and well tinned and when replacing parts.
• A close inspection of the circuit board revealed look in good condition.
• After repaired, must connect source to each port to check Main board function is
ordinary.
Note: (The requirement of professional repairers’ regulation by ERP lot5)
(1) The professional repairer has the technical competence to repair electronic
displays and complies with the applicable regulations for repairers of electrical
equipment in the Member States where it operates. Reference to an official
registration system as professional repairer, where such system exists in the
Member States concerned, shall be accepted as proof of compliance with this
point.
(2) The professional repairer is covered by insurance covering liabilities resulting from
its activity, regardless of whether this is required by the Member State.

HP OMEN X 27 Specifications

General

Cables included	DisplayPort, HDMI, USB Type-A to USB Type-B
3D	No
Panel type	TN
Pixel pitch	0.233 x 0.233 mm
Screen shape	Flat
Backlight type	LED
Display diagonal	27 \
Display technology	-
Native aspect ratio	16:9
Maximum refresh rate	240 Hz
Viewable size, vertical	335.6 mm
Viewing angle, vertical	160 °
Contrast ratio (typical)	1000:1
Display number of colors	16.78 million colors
Viewable size, horizontal	596.7 mm
Viewing angle, horizontal	170 °
Display brightness (typical)	300 cd/m²
Supported graphics resolutions	640 x 480 (VGA), 720 x 400, 800 x 600 (SVGA), 1024 x 768 (XGA), 1280 x 720 (HD 720), 1280 x 800 (WXGA), 1440 x 900 (WXGA+), 1440 x 900, 1600 x 900, 1680 x 1050 (WSXGA+), 1920 x 1080 (HD 1080), 2560 x 1440
Product color	Black
Country of origin	China
Market positioning	Gaming
Tilt angle range	-5 - 23 °
On Screen Display (OSD)	Yes
HP segment	Home
USB hub version	3.2 Gen 1 (3.1 Gen 1)
DisplayPort version	1.4
VGA (D-Sub) ports quantity	0
AC input voltage	100 - 240 V
AC input frequency	50 - 60 Hz
Power consumption (max)	65 W
Power consumption (off)	0.29 W
Annual energy consumption	66 kWh
Power consumption (standby)	0.45 W
Power consumption (typical)	30 W
Operating temperature (T-T)	5 - 35 °C
Operating relative humidity (H-H)	20 - 80 %
Package depth	272.5 mm
Package width	557.5 mm
Package height	489.6 mm
Package weight	10600 g
Depth	330.6 mm
Height	98.7 mm

Weight and Dimensions

Depth (with stand)	53.36 mm
Width (with stand)	61.36 mm
Height (with stand)	27.25 mm
Weight (with stand)	7100 g
Depth (without stand)	10.04 mm
Width (without stand)	613.6 mm
Height (without stand)	37.36 mm
Weight (without stand)	- g