a. Use a tweezer to grasp the tape that routes behind both the left and right sides of the display panel
(1).
b. Roll the tape around the tweezer as you pull the tape out from behind the left and right sides of
the panel (2).
IMPORTANT: To avoid tearing the tape, pull the tape evenly and carefully.
TIP: You have to pull on the tape multiple times before it is completely removed.
c. Lift the top of the panel up and rotate the panel over next to the display back cover (3).
d. Remove the tape from the connector on the back of the display panel (1), and then disconnect the
cable from the panel (2).
Component replacement procedures 53
To Next Page
Loading...
