Installing the disk enclosure
1. Slide the device into position on the rails (1, Figure 2 (page 5)) and then tighten the thumbscrews
(2) on the front of the device to secure the device to the rack.
Figure 2 Secure disk enclosure to rack
NOTE: The rear ends of the rails have a CTO bracket that must engage the device chassis to
secure the rear of the chassis to the rails.
Figure 3 Engaging CTO bracket
2. When cabling the device, use holes provided in the rear rack rails, install tie wraps, and route
external cable as required.
Installing the disk enclosure 5
To Next Page
Loading...
