Solid-state drive
Description Spare part number
512-GB, PCIe, NVMe L37357-001
256-GB, PCIe, NVMe, TLC L38076-001
256-GB, PCIe, NVMe L37356-001
256-GB, SATA-3, TLC L38042-001
128-GB, SATA-3, TLC L37355-001
Before removing the solid-state drive, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is o or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by rst unplugging the power cord from the AC outlet, and
then unplugging the AC adapter from the computer.
4. Remove the bottom cover (see Bottom cover on page 25).
5. Disconnect the battery (see Battery on page 27).
Remove the solid-state drive:
1. Remove the Phillips M2.0×3.0 screw (1) that secures the drive to the computer.
2. Remove the drive (2) by pulling it away from the connector.
Reverse this procedure to install the solid-state drive.
30 Chapter 5 Removal and replacement procedures for Authorized Service Provider parts
To Next Page
Loading...
Need help?
General
