Hard drive
NOTE: All hard drive spare part kits include a hard drive bracket.
NOTE: The hard drive cable is included in the Misc Cable Kit, spare part number 608227-001.
Description Spare part number
750-GB, 7200 RPM 678103-001
640-GB, 7200 RPM 678102-001
500-GB, 7200 RPM 678101-001
320-GB, 7200 RPM 678100-001
Hard drive mounting hardware 672516-001
Before removing the hard drive, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet
and then unplugging the AC adapter from the computer.
4. Remove the battery (see
Battery on page 42).
5. Remove the memory/wireless module compartment cover (see
Memory module on page 44)
Remove the hard drive:
1. Position the computer with the front toward you.
2. Loosen the two captive Phillips PM2.5×5.0 screws (1) that secure the hard drive cover to the
computer.
3. Lift the cover up at an angle (2) and remove it (3). The hard drive cover is included in the plastics
kit, spare part number 608233-001.
4. Disconnect the hard drive cable from the system board (1).
Component replacement procedures 53
To Next Page
Loading...
