Computer feet
Description Spare part number
Rubber Kit (includes base enclosure rubber feet and display bezel screw covers) 431430-001
The computer feet are adhesive-backed rubber pads. The feet attach to the base enclosure in the locations
illustrated below.
Memory module
Description Spare part number
2048-MB (PC2-5300, 667-MHz, DDR2) 453774-001
1024-MB (PC2-5300, 667-MHz, DDR2) 446495-001
512-MB (PC2-5300, 667-MHz, DDR2) 446494-001
Before removing the memory module, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet and
then unplugging the AC adapter from the computer.
4. Remove the battery (see
Battery on page 41).
Remove the memory module:
1. Position the computer with the front toward you.
2. Loosen the two Phillips PM2.0×5.0 screws (1) that secure the memory/WLAN module compartment
cover to the computer.
48 Chapter 4 Removal and replacement procedures
To Next Page
Loading...
Need help?
General
