2.
Remove the memory module (2) by pulling it away from the slot at an angle.
CAUTION: To prevent damage to the memory module, hold the memory module by the edges
only. Do not touch the components on the memory module.
CAUTION: To protect a memory module after removal, place it in an electrostatic-safe
container.
3.
Align the notched edge (1) of the memory module with the tab in the memory module slot.
4. With the memory module at a 45-degree angle from the surface of the memory module
compartment, press the module into the memory module slot (2) until it is fully seated.
46 Chapter 4 Removal and replacement procedures ENWW
To Next Page
Loading...
