HP Prime Graphing Calculator - Program Catalog and Editor

59
59
When there are existing programs, the menu items in the Program Catalog are:
• : opens the Program Editor with the selected program shown for you to edit
• : opens an input box for you to name a new program
• : opens a sub-menu with the following options:
 Save: create a copy of a program with a new name
 Rename: rename an existing program
 Sort: sort the programs (either chronologically or alphabetically)
 Delete: delete the selected program
 Clear: delete all programs in the Program Catalog
• : sends the selected program to another HP Prime
• : debugs the selected program
• : runs the selected program
You can enter your program letter-by-letter if you know the command names, or use one of the
menus available when the Program Editor is open:
• : opens the commands menu
• : opens a menu of common branch and loop structures
Note that the programming commands are also available from the Catlg menu (see page 55).
The button enables you to check your syntax at any time.
Once you have finished your program, return to the Program Catalog by pressing Sx (Program). You will see it listed in the
catalog. Tap
to run your program. (In Home view you can enter your program’s name and press E to run it.)