Connector Name Connector Color Description
SATA2 light blue Second hard drive
SATA3 orange Second optical drive
Drives
A Torx T-15 screwdriver is needed to remove and install the guide screws on a drive.
Drive Positions
NOTE: Your computer model may look different than the model shown below. Diskette drives are
only available on some models.
Figure 7-16 Drive Positions
1 3.5-inch external drive bay for optional drive (diskette drive shown)
2 3.5-inch internal hard drive bay
3 5.25-inch external drive bay for optional drive (optical drive shown)
To verify the type, size, and capacity of the storage devices installed in the computer, run Computer
Setup. Refer to the Computer Setup (F10) Utility Guide for more information.
Drives 101
To Next Page
Loading...
