M.2 solid-state drive
Table 5-6 Solid-state drive descriptions and part numbers
Description Spare part number
512 GB, PCIe, TLC L78063-001
512 GB, PCIe, value L78064-001
512 GB PCIe + 32 GB Optane memory L85514-001
256 GB, PCIe, value L78062-001
256 GB PCIe + 16 GB Optane memory L85343-001
128 GB, SATA-3, TLC L78061-001
Before removing the solid-state drive, follow these steps:
1. Prepare the computer for disassembly (Preparation for disassembly on page 33).
2. Place the computer in Battery Safe mode (Battery Safe mode on page 33).
3. Remove the bottom cover (Bottom cover on page 34).
4. Remove the battery (Battery on page 36).
Remove the solid-state drive:
1. Remove the Phillips M2.0 × 2.5 screw (1) that secures the solid-state drive to the computer.
2. Remove the solid-state drive (2) by pulling the module away from the slot at an angle.
Reverse this procedure to install the solid-state drive.
Component replacement procedures 43
To Next Page
Loading...
