M.2 solid-state drive
Table 5-5 Solid-state drive description and part number
Description Spare part number
512 GB, PCIe, TLC L52220-001
256 GB, PCIe L52219-001
128 GB, SATA-3, TLC L52218-001
Before removing the solid-state drive, follow these steps:
1. Prepare the computer for disassembly (Preparation for disassembly on page 34).
2. Place the computer in “Battery Safe mode” (Battery Safe mode on page 34).
3. Remove the bottom cover (Bottom cover on page 35).
4. Remove the battery (Battery on page 36).
Remove the solid-state drive:
1. Remove the Phillips M2.0 × 2.5 screw (1) that secures the solid-state drive to the computer.
2. Remove the solid-state drive (2) by pulling the module away from the slot at an angle.
Reverse this procedure to install the solid-state drive.
40 Chapter 5 Removal and replacement procedures for Customer Self-Repair parts
To Next Page
Loading...
