Fingerprint sensor assembly
Table 6-6 Fingerprint sensor assembly description and part number
Description Spare part number
Fingerprint sensor assembly L44516-001
Fingerprint sensor bracket (included in Bracket Kit) L44586-001
Fingerprint sensor cable (included in the Cable Kit) L52216-001
Fingerprint sensor insert (included in Plastics Kit; for use in models without a ngerprint sensor) L44551-001
Before removing the ngerprint sensor assembly, follow these steps:
1. Prepare the computer for disassembly (Preparation for disassembly on page 34).
2. Place the computer in “Battery Safe mode” (Battery Safe mode on page 34).
3. Remove the following components:
a. Bottom cover (Bottom cover on page 35).
b. Battery (Battery on page 36).
c. Hard drive (Hard drive on page 41)
Remove the ngerprint sensor assembly:
1. Disconnect the cable from the ZIF connector on the ngerprint sensor (1).
2. Slide the bracket toward the inside of the computer, and then lift it o the ngerprint sensor board (2).
TIP: A tool may be required to push and disengage the bracket.
Component replacement procedures 51
To Next Page
Loading...
