Display assembly
Non-touch displays are ONLY spared at the subcomponent level. For more information about display
components, see Display components on page 21.
Before removing the display assembly, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is o or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by rst unplugging the power cord from the AC outlet, and
then unplugging the AC adapter from the computer.
4. Remove the battery (see Battery on page 32).
5. Remove the following components:
a. Service doors (see Service doors on page 33).
b. Optical drive (Optical drive on page 35)
c. Hard drive (see Hard drive on page 37)
d. WLAN module (see WLAN/Bluetooth combo card on page 41)
e. Keyboard (see Keyboard on page 43)
f. Top cover (see Top cover on page 48)
Remove the display assembly:
1. Position the computer upright and open.
2. Disconnect the display cable from the system board (1).
3. Pull the antennas through the hole in the computer (2), and then remove them from the routing path
near the right display hinge (3).
4. Remove the 5 Phillips PM2.5×5.0 screws (3) from the display hinges.
Component replacement procedures 75
To Next Page
Loading...
