Solid-state drive
To remove the M.2 solid-state drive, use this procedure and illustration.
Table 5-3 Solid-state drive descriptions and part numbers
Description Spare part number
1 TB, PCIe, TLC L85348-001
512 GB, PCIe, TLC L85360-001
512 GB, PCIe, value L85364-001
256 GB, PCIe, TLC L85350-001
256 GB, PCIe, value L85354-001
128 GB, M.2 2280, PCIe-3×2, TLC M06792-001
Solid-state drive cover (included in Miscellaneous Parts Kit) M30663-001
Before removing the solid-state drive, follow these steps:
1. Prepare the computer for disassembly (see Preparation for disassembly on page 35).
2. Remove the bottom cover (see Bottom cover on page 35).
3. Disconnect the battery cable from the system board (see Battery on page 43).
Remove the solid-state drive:
▲ Use the tab (1) to lift the cover o the solid-state drive (2). The cover is held in place by clips on the system
board.
40 Chapter 5 Removal and replacement procedures for Customer Self-Repair parts
To Next Page
Loading...
