3. Remove the power connector cable from the computer (4).
Reverse this procedure to install the power connector cable.
USB board
To remove the USB board, use this procedure and illustration.
Table 6-7
USB board description and part number
Description Spare part number
USB board M36398-001
USB board cables (included in Cable Kit) M30646-001
Before removing the USB board, follow these steps:
1. Prepare the computer for disassembly (see Preparation for disassembly on page 43).
2. Remove the bottom cover (see Bottom cover on page 35).
3. Disconnect the battery cable from the system board (see Battery on page 43).
Remove the USB board:
1. Disconnect the smaller cable from the USB board (1).
2. Disconnect the larger cable from the ZIF connector on the USB board (2).
3. Remove the three Phillips M2.0 × 4.0 screws (3).
USB board
51
To Next Page
Loading...
