3. Remove the ngerprint reader board from the computer (4).
Reverse this procedure to install the ngerprint reader board.
Touchpad
To remove the touchpad, use this procedure and illustration.
Table 6-9
Touchpad description and part number
Description Spare part number
Touchpad (not available as a spare part component)
Touchpad cable (included in Cable Kit) M30646-001
Before removing the touchpad, follow these steps:
1. Prepare the computer for disassembly (see Preparation for disassembly on page 43).
2. Remove the bottom cover (see Bottom cover on page 35).
3. Remove the battery (see Battery on page 43).
Remove the touchpad:
1. Disconnect the cable from the ZIF connector on the touchpad (1).
2. Remove the three Phillips M2.0 × 2.0 screws (2) that secure the touchpad to the computer.
Touchpad
53
To Next Page
Loading...
