f. Remove the panel (5).
8. When replacing the display panel, follow these steps:
IMPORTANT: Before installing the display panel, be sure to install the display cable on the back of the
panel.
a. Peel the protective layer from the bottom of the adhesive strips (1).
b. Starting near the bottom of the inside of the display back cover (2), install the adhesive strips on both
the left and right sides by aligning them with the groove on the edge of cover (3).
c. Peel the protective layer from the top of the adhesive strips (4).
d. Install the previously selected alignment tools onto the upper left and right corners of the display rear
cover (5).
e. Insert the top of the panel into the top of the display rear cover (6), and then rotate the panel into
place (7). Be sure that the upper corners of the panel are positioned up against the insides of the
alignment tools.
The double-sided adhesive strips are available using spare part number M33161-001.
64 Chapter 6 Removal and replacement procedures for authorized service provider parts
To Next Page
Loading...
