e. Remove the display panel cable (1) from the rubber cable clip (2) that was removed from the left
display hinge.
The display panel cable is included in the Cable Kit, spare part number 917064-001.
16. If it is necessary to replace the wireless antenna cables and transceivers:
a. Remove the display bezel.
b. Remove the display panel.
c. Remove the display hinges.
d. Detach the retention tape (1) that secures the wireless antenna cables to the display back cover
near the right hinge.
e. Release the wireless antenna cables from the retention clips (2) built into the bottom right corner
of the display back cover.
f. Release the wireless antenna cables from the retention tabs (3) on the right edge of
the display back cover.
g. Release the wireless antenna cables from the retention clips (4) and routing channel (5) built into
the right edge of the display back cover.
h. Release the wireless antenna cables (6) from the rubber cable clip that was removed from the right
display hinge.
48 Chapter 4 Removal and replacement procedures
To Next Page
Loading...
