i. Detach the wireless antenna transceivers (7) from the display back cover. (The wireless antenna
transceivers are attached to the display back cover with double-sided adhesive.)
j. Remove the wireless antenna cables and transceivers.
The wireless antenna cables and transceivers are available using spare part number 918173-001.
17. If it is necessary to replace the webcam/microphone module:
a. Remove the display bezel.
b. Remove the display panel.
c. Remove the display hinges.
d. Remove the wireless antenna cables and transceivers.
e. Release the webcam/microphone module cable from the retention clips (1) and routing channel
built into the right edge of the display back cover.
f. Disconnect the LED board cable (2) from the LED board.
Component replacement procedures 49
To Next Page
Loading...
