1. Prepare the computer for disassembly (Preparation for disassembly on page 29).
2. Remove the bottom cover (Bottom cover on page 29).
3. Remove the battery (see Battery on page 30).
Remove the rear camera:
1. To remove the camera board, disconnect the camera module cable (1) and the system board cable (2)
from the ZIF connectors on the camera board.
2. Remove the M2.0 × 3.0 screw (3) that secures the board, and then remove the board from the computer
(4).
3. To remove the camera module, disconnect the camera cable from the ZIF connector on the camera
board (1).
40 Chapter 5 Removal and replacement procedures for authorized service provider parts
To Next Page
Loading...
