HP ProBook x360 435 G7 - Fingerprint Sensor

Before removing the speaker, follow these steps:
1. Prepare the computer for disassembly (Preparation for disassembly on page 29).
2. Remove the bottom cover (Bottom cover on page 29).
3. Remove the battery (see Battery on page 30).
4. Remove the fan (see Fan on page 41).
5. Remove the system board (see System board on page 45).
Remove the speaker:
1. Remove the Phillips M2.0 × 3.0 screw (1) that secures the speaker to the computer.
2. Remove the speaker from the computer (2) .
Reverse this procedure to install the speaker.
Fingerprint sensor
To remove the ngerprint sensor, use this procedure and illustration.
Table
5-14 Fingerprint sensor description and part number
Description Spare part number
Fingerprint sensor
NOTE: The ngerprint sensor cable is available in the Cable Kit, spare part number M03431-001. The
ngerprint sensor bracket is available in the Bracket Kit, spare part number M03436-001.
M03434-001
Before removing the ngerprint sensor, follow these steps:
1. Prepare the computer for disassembly (Preparation for disassembly on page 29).
2. Remove the bottom cover (Bottom cover on page 29).
3. Remove the battery (see Battery on page 30).
4. Remove the fan (see Fan on page 41).
5. Remove the system board (see System board on page 45).
48 Chapter 5 Removal and replacement procedures for authorized service provider parts