4. Remove the two M2.0 × 3.0 screws (2) that secure the camera module bracket, remove the bracket (3),
and then remove the camera (4).
Reverse this procedure to install the rear camera and rear camera board.
Fan
To remove the fan, use this procedure and illustration.
Table
5-9 Fan description and part number
Description Spare part number
Fan assembly M03432-001
Before removing the fan, follow these steps:
1. Prepare the computer for disassembly (Preparation for disassembly on page 29).
2. Remove the bottom cover (Bottom cover on page 29).
3. Remove the battery (see Battery on page 30).
Remove the fan assembly:
1. Disconnect the fan cable from the system board (1).
Component replacement procedures 41
To Next Page
Loading...
