HP ProCurve 1400-24G User Manual

2-8
Installing the Switch
Installation Procedure
Installing the Switch
3. Place the switch in the rack and lower it so the notches in the bottom of
the bracket slide onto the screws, then tighten these screws.
4. Install the other number 12-24 screw into the upper hole in each bracket.
Tighten these screws.
Lower switch with mounting
brackets onto the partially
installed screw
Install additional
screw

HP ProCurve 1400-24G Specifications

General

Brand	HP
Model	ProCurve 1400-24G
Category	Switch
Language	English