8
Installing the Switch
If the LED display is different than what is described above, especially if
the Fault and Test LEDs stay on for more than 60 seconds or they start
blinking, the self test has not completed correctly. Refer to “Trouble-
shooting” for diagnostic help.
3. Mount the Switch
The Switch 2810 can be mounted in these ways:
■ in a rack or cabinet
■ on a horizontal surface
■ on a wall
Rack or Cabinet Mounting
The Switch 2810 is designed to be mounted in any EIA-standard 19-inch telco
rack or communication equipment cabinet.
Warning For safe operation, please read the “Installation Precautions” on
page 5, before mounting a switch.
Equipment
Cabinet
Note
The 12-24 screws supplied with the switch are the correct threading for
standard EIA/TIA open 19-inch racks. If you are installing the switch in an
equipment cabinet such as a server cabinet, use the clips and screws that came
with the cabinet in place of the 12-24 screws that are supplied with the switch.
To Next Page
Loading...
