EasyManuals Logo
Home>HP>Switch>ProCurve 5308xl

HP ProCurve 5308xl User Manual

HP ProCurve 5308xl
664 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #142 background imageLoading...
Page #142 background image
PIM-DM (Dense Mode) on the 5300xl Switches
Configuring PIM-DM on the Series 5300xl Switches
For example, if multiple routers are connected to the same
VLAN and the routing switch requests multicast traffic, all
routers on the VLAN receive that traffic. (Those which have
pruned the traffic will drop it when they receive it.) If the
upstream router loses contact with the routing switch
receiving the multicast traffic (that is, fails to receive a Hello
packet when expected), then the shorter Hello Interval causes
it to stop transmitting multicast traffic onto the VLAN
sooner, resulting in less unnecessary bandwidth usage.
Not used with the no form of the ip pim command.
Syntax: ip pim [ hello-delay < 0 - 5 >]
vlan < vid > ip pim [ hello-delay < 0 - 5 >]
Changes the maximum time in seconds before the routing
switch actually transmits the initial PIM Hello message on
the current VLAN. In cases where a new VLAN activates with
connections to multiple routers, if all of the connected
routers sent Hello packets at the same time, then the
receiving router could become momentarily overloaded. This
value randomizes the transmission delay to a time between
0 and the hello delay setting. Using0means no delay. After
the routing switch sends the initial Hello Packet to a newly
detected VLAN interface, it sends subsequent Hello packets
according to the current Hello Interval setting. Not used with
the no form of the ip pim command. Default: 5 seconds.
Syntax: ip pim [ graft-retry-interval < 1-10 >]
vlan < vid > ip pim [ graft-retry-interval < 1-10 >]
Graft packets result when a downstream router transmits a
request to join a flow. The upstream router responds with a
graft acknowledgment packet. If the Graft Ack is not received
within the time period of the graft-retry-interval, it resends
the graft packet. This command changes the interval (in
seconds) the routing switch waits for the Graft Ack
(acknowledgement) from another router before resending
the Graft request. Not used with the no form of the ip pim
command. (Default: 3 seconds.)
5-16

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the HP ProCurve 5308xl and is the answer not in the manual?

HP ProCurve 5308xl Specifications

General IconGeneral
BrandHP
ModelProCurve 5308xl
CategorySwitch
LanguageEnglish

Related product manuals