Quality of Service (QoS): Managing Bandwidth More Effectively
Using QoS Classifiers To Configure Quality of Service for Outbound Traffic
2. Change the classifier configurations by assigning them to a different DSCP
policy, or to an 802.1p priority, or to No-override. For example:
a. Delete the policy assignment for the device-priority classifier. (That is,
assign it to No-override.)
b. Create a new DSCP policy to use for re-assigning the remaining
classifiers.
c. Assign the port-priority classifier to the new DSCP policy.
d. Assign the udp-port 1260 classifier to an 802.1p priority.
3. Reconfigure the desired priority for the 000001 codepoint.
HPswitch(config)# qos dscp-map 000001 priority 4
4. You could now re-assign the classifiers to the original policy codepoint or
leave them as currently configured.
8-68
To Next Page
Loading...
Need help?
General