33
Restoring the Factory Default Configuration
Restoring Factory Firmware
This feature is built into the boot ROM, and it provides a way to recover from a situation where
both primary and secondary images are not bootable. Since the xmodem download will not
work on the 6120XG or the 6120G/XG switch, this is the mechanism to use in case both images
are not bootable. Required user action is highlighted.
ROM information:
Build directory: /sw/rom/build/vernrom(titan4_v14_release)
Build date: July 9 2009
Build time: 10:54:18
Build version: Z.14.03
Build number: 25751
Boot Profiles:
0. Monitor ROM Console
1. Primary Software Image
2. Secondary Software Image
516733-B21:HP ProCurve 6120XG Blade Switch
ROM Build Directory: /sw/rom/build/vernrom(titan4_v14_release)
ROM Version: Z.14.03
ROM Build Date: 10:54:18 Jul 9 2009
ROM Build Number: 25751
Copyright (c) 1995-2008 Hewlett-Packard Company. All rights reserved.
RESTRICTED RIGHTS LEGEND
Use, duplication, or disclosure by the Government is subject to restrictions
as set forth in subdivision (b) (3) (ii) of the Rights in Technical Data and
Computer Software clause at 52.227-7013.
Hewlett-Packard Company, 3000 Hanover Street, Palo Alto, CA 94303
Enter h or ? for help.
***************************************************************************
* *
* You've invoked the Product Recovery command. *
* *
* Product Recovery is intended for use when neither the Primary nor the *
* Secondary product images are bootable. *
* *
* If you continue, this command will do the following: *
* 1. Overwrite Primary with the original factory released image. *
* 2. Clear configuration and boot the new Primary product code. *
* *
* The recovery process will take about 4 minutes to complete, please do *
* not reset or power off the system during recovery. If you do not wish *
* to perform Recovery at this time, enter 'C' at the prompt to Cancel. *
* *
****************************************************************************
Select profile (secondary):0
=>recover
Please confirm! Enter 'P' to Proceed, or 'C' to Cancel: p
To Next Page
Loading...
Need help?
General