Speaker
Follow these steps to remove the speaker:
1. Prepare the computer for disassembly (see Preparation for disassembly on page 32).
2. Remove the access panel (see Access panel on page 33).
3. Remove the front bezel (see Front bezel on page 36).
4. Remove the drive cage (see Drive cage on page 40).
Remove the speaker:
1. Position the computer with the front panel toward you.
2. Disconnect the speaker cable (1) from the system board.
3. Remove the two Torx-15 M3.0×9.0 screws (2) that secure the speaker to the computer chassis.
4. Remove the speaker (3).
Reverse this procedure to install the speaker.
46 Chapter 4 Removal and replacement procedures
To Next Page
Loading...
