Removal and replacement procedures 39
2.
Remove the thermal interface protective cover from the heatsink.
CAUTION: To avoid damage to the system board, processor socket, and screws, do not
overtighten the heatsink screws. Use the wrench supplied with the system to reduce the possibility
of overtightening the screws.
3. Align and install the heatsink. Alternate tightening the screws until the heatsink is seated properly.
4. Install the front panel/hard drive cage assembly ("Front panel/hard drive cage assembly" on page
33).
5. Install the hard drive backplane ("Hard drive backplane" on page 32).
6. Install the hard drives ("Hard drive" on page 26).
7. Install the hard drive blanks ("Hard drive blank" on page 26).
8. Install the access panel ("Access panel" on page 25).
9. Install the server blade.
To Next Page
Loading...
