HP ProLiant BL460c G7 - System Board

Removal and replacement procedures 45
5.
Align and install the heatsink. Alternate tightening the screws until the heatsink is seated properly.
6. Install the front panel/hard drive cage assembly ("Front panel/hard drive cage assembly" on page
33).
7. Install the hard drive backplane ("Hard drive backplane" on page 32).
8. Install the hard drives ("Hard drive" on page 26).
9. Install the hard drive blanks ("Hard drive blank" on page 26).
10. Install the access panel ("Access panel" on page 25).
11. Install the server blade.
System board
To remove the component:
1. Power down the server blade (on page 23).
2. Remove the server blade (on page 24).
3. Remove the access panel ("Access panel" on page 25).
4. Remove all hard drives ("Hard drive" on page 26).
5. Remove all hard drive blanks ("Hard drive blank" on page 26).
6. Remove the hard drive backplane ("Hard drive backplane" on page 32).
7. Remove the front panel/hard drive cage assembly ("Front panel/hard drive cage assembly" on page
33).
8. Remove all DIMMs ("DIMMs" on page 29).
9. Remove all mezzanine cards, if installed ("Mezzanine card" on page 31).
10. Remove the heatsink ("Heatsink" on page 38).