HP ProLiant DL360 G7 - NMI Jumper; Systems Insight Display LEDs

No. Task Reference Avaya recommendation
1 Power down server if the
part being replaced is
not hot-swappable.
MSG: Power down the
server
Determine whether the
replaceable component is hot-
swappable.
2 Slide the server out of
the rack if required to
access the part being
replaced.
MSG: Extend the server
from the rack
MSG: Remove the server
from the rack
Check that the Cable
Management Arm (if present)
moves freely out of the way of
rear panel components.
3 Replace the component:
• DL360G7 SRVR
146GB 10K SAS 2.5”
HDD
• DL360G7 SRVR
146GB 15K SAS 2.5”
HDD
• DL360G7 SRVR
300GB 10K SAS 2.5”
HDD
MSG: Removal and
replacement procedures >
SAS and SATA hard drive
MSG: Removal and
replacement procedures >
Hard drive blank
• DL360G7 SRVR PWR
SUP 460W HE
• DL360G7 SRVR AC
PWR SUP 750W
• DL360G7 SRVR DC
PWR SUP 1200W
MSG: Removal and
replacement procedures >
Hotplug power supply
MSG: Removal and
replacement procedures >
Power supply blank
Ensure that the replacement
power supply matches the
specifications of the defective
power supply.
4 Slide the server into the
rack (if slid out)
UG: Installing the server
into the rack
Check that the Cable
Management Arm (if present)
moves freely out of the way of
rear panel components.
5 Connect the power
cable(s) to the power
supply (if disconnected)
UG: Powering up and
configuring the server
6 Power up the server (if
powered down)
UG: Power up the server
Replacing internal components
Use the checklist below to replace any of these internal server components:
Replacing internal components
November 2010 Maintaining and Troubleshooting the HP ProLiant DL360 G7 Server 13
Comments on this document? infodev@avaya.com