HP ProLiant DL360 G7 - Page 15

No. Task Reference Avaya recommendation
• DL360G7 SRVR DUAL
PORT 1GB NIC
MSG: Removal and
replacement procedures:
• PCI riser board assembly
• Expansion boards
• PCIe riser board
Mark any cables connected
to the NIC and reconnect to
the same ports after the NIC
is replaced.
The NIC requires a half-HT
faceplate. You might need to
remove the full faceplate and
replace it with the half
faceplate, which requires a
crosshatch (Phillips)
screwdriver.
Note:
If adding a NICs:
populate PCI Slot 1 first,
followed by Slot 2.
• DL360G7 SRVR FAN
FRU
MSG: Removal and
replacement procedures > Fan
module
Refer to the Systems Insight
Display LEDs to identify the
defective fan.
• DL360G7 SRVR 2GB
MEMORY DIMM
• DL360G7 SRVR 4GB
MEMORY DIMM
MSG: Removal and
replacement procedures >
DIMMs
Refer to the Systems Insight
Display LEDs to identify the
defective DIMM.
Caution:
When removing the air
baffle, ensure that the
RAID battery does not
fall out of its
compartment in the
baffle.
Caution:
Refer to the information
on the top of the air
baffle and inside cover
for correct DIMM
placement.
• DL360G7 SRVR 650
MAH RAID BATTERY
MSG: Removal and
replacement procedures >
BBWC battery pack or FBWC
capacitor pack
Caution:
Consult the internal
label with directions for
removing the air baffle.
Be careful that the RAID
battery does not fall out
Table continues…
Replacing internal components
November 2010 Maintaining and Troubleshooting the HP ProLiant DL360 G7 Server 15
Comments on this document? infodev@avaya.com