HPE ProLiant DL380 Generation9 (Gen9)
NOTE: Some options may not be integrated at the factory. To ensure only valid configurations are ordered, Hewlett Packard
Enterprise recommends the use of an HPE approved configurator. Contact your local sales representative for additional
Options
HP DL380 Gen9 NVMe 6 Solid State Drive Express Bay Enablement Kit
NOTE: This option provides support for up to 6NVMe drives, and can only be
populated in BAY2 in SFF chassis only, can be used with Bay1 and Bay 3
populated.
NOTE: The HPE DL380 Gen9 High Performance Fan Kit is required for NVMe
support (719079-B21).
NOTE: The PCIe card in this enablement kit can only be populated in slot2
(primary) or slot 5 (secondary).
NOTE: For true x16 support with this option a secondary riser (719073-B21) is
needed (second processor required).
NOTE: Kit includes Mylar film for Universal Media Bay (724865-B21) support
to ensure optimal airflow.
NOTE: There are limitations on GPU support with the NVMe
bay installed.
HP DL380 Gen9 Universal Media Bay Kit
NOTE: The HPE DL380 Gen9 Universal Media bay provides front VGA and
2xUSB 2.0; plus support for 2xSFF front drives (724864-B21) and ODD
support (No included); and can only be located in Bay1 in either an 8SFF or
8+8SFF model.
HP DL380 Gen9 Graphics Enablement Kit
NOTE: This kit includes alternative 2 heatsinks plus6 cables to enable GPU
support. Other limitations apply, see Graphic section for more details.
NOTE: We support up to 2 Double wide and 3 single wide Graphics cards,
limitations apply.
NOTE: Double Wide GPUs will occupy slots 2 and 5 and will leave only 2 slots
left open.
NOTE: There are limitations on GPU support with the NVMe bay installed.
HP DL380 Gen9 High Performance Fan Kit
NOTE: This kit is required for specific Ambient temperature environments,
more details here: http://www.hp.com/servers/Ashrae.
NOTE: This kit is also required to support Passive GPUs.
NOTE: This kit provides max cooling for your Server.
HP DL380 Gen9 2SFF Front/Rear SAS/SATA Kit
NOTE: For 2SFF front the Universal Media Bay (724865-B21) is required.
NOTE: 2SFF in the rear is only supported with a 24SFF (CTO server or field
upgraded) or 12LFF (719061-B21) model.
NOTE: Rear drives are only supported with the following processor
characteristics: 145W, 22/18/16 Cores; 135W, 20/8/6/4 Cores; 120W,
18/16/14 Cores; 105W, 14/12 Cores; 90W, 10 Cores; 85W, 10/8/6/4 Cores;
65W, 14 Cores and 55W, 10 Cores.
HP DL380 Gen9 3LFF Rear SAS/SATA Kit
NOTE: This is only supported in the 12LFF model (719061-B21).
NOTE: 3LFF rear drives will consume the 2nd riser expansion slot.
NOTE: 3LFF Rear drives are only supported with the following processor
characteristics: 145W, 22/18/16 Cores; 135W, 20/8/6/4 Cores; 120W,
18/16/14 Cores; 105W, 14/12 Cores; 90W, 10 Cores; 85W, 10/8/6/4 Cores;
65W, 14 Cores and 55W, 10 Cores.
HP DL380 Gen9 Primary 2 Slot GPU Ready Riser Kit
To Next Page
Loading...
