o
To remove slot covers 5 and 6, push down on the latch, rotate the latch down, and then remove
the cover.
Expansion boards
Half-length expansion board
To remove the component:
1. Power down the server (on page 26).
2. Extend the server from the rack (on page 25).
3. Remove the access panel ("Access panel" on page 32).
4. Disconnect any external cables that are connected to the expansion board.
5. Remove the PCI riser cage ("PCI riser cage" on page 36).
6. Disconnect any internal cables that are connected to the expansion board.
Removal and replacement procedures 38
To Next Page
Loading...
