HP ProLiant DL385 G6 - Page 43

Fan cage
To remove the component:
1. Power down the server (on page 26).
2. Extend or remove the server from the rack ("Extend the server from the rack" on page 25, "Remove
the server from the rack
" on page 27).
3. Remove the access panel ("Access panel" on page 32).
4. Remove the PCI riser cage ("PCI riser cage" on page 36).
5. Remove the air baffle ("Air baffle" on page 42).
6. Remove the fan blanks.
7. Remove the fans ("Hot-plug fan" on page 33).
8. Remove the fan cage.
To replace the component, reverse the removal steps and press down on the top of each fan to be sure it
is seated properly.
Heatsink
To remove the heatsink:
1. Power down the server (on page 26).
2. Extend the server from the rack (on page 25).
3. Remove the access panel ("Access panel" on page 32).
4. Remove the PCI riser cage ("PCI riser cage" on page 36).
5. Remove the air baffle ("Air baffle" on page 42).
Removal and replacement procedures 43