CAUTION: To prevent possible server malfunction and damage to the equipment,
multiprocessor configurations must contain processors with the same part number.
To remove a processor:
1. Power down the server (on page 26).
2. Extend the server from the rack (on page 25).
3. Remove the access panel ("Access panel" on page 32).
4. Remove the PCI riser cage ("PCI riser cage" on page 36).
5. Remove the air baffle ("Air baffle" on page 42).
6. Remove the heatsink ("Heatsink" on page 43).
7. Open the processor retaining latch and the processor socket retaining bracket.
8. Using your fingers, remove the failed processor.
To replace a processor:
Removal and replacement procedures 46
To Next Page
Loading...
