HP ProLiant DL585 Generation 2 - Processor Memory Module Bezel

Removal and replacement procedures 35
3.
Press the tabs behind the bezel and pull the bezel away from the server. If necessary, use a flathead
screwdriver to press the tabs.
To replace the component, reverse the removal procedure.
Processor memory module bezel
1. Power down the server (on page 26).
2. Remove the processor memory module, and open the cover ("Removing the processor memory
module" on page 29).
3. Press the tabs to disconnect the bottom of the bezel and pull the bezel away from the server. If
necessary, use a flathead screwdriver to press the tabs.
To replace the component, reverse the removal procedure.