Installing an accessory card
Figure 6 Installing an accessory card
Installing hard drives
This system can support SATA and SAS drives in non-hot-plug and
hot-plug hard disk drive cages.
For detailed drive cabling information, see the server hood label.
Non-hot-plug drive installation
Figure 7 Removing a non-hot-plug hard drive cage
Figure 8 Installing a non-hot-plug drive
Hot-plug drive installation
Figure 9 Installing a hot-plug-drive
Installing optical drives
The lower two half-height media bays are shipped with drive bay
shields. Remove a shield by pulling it away from the front of the
chassis.
Figure 10 Removing an optical drive bay shield
To Next Page
Loading...
