HP Server ROM
HP ROM (Read Only Memory) is now digitally signed using HP's Corporate Signing Service. This signature is
verified before the flash process starts, reducing accidental programming and preventing malicious efforts
to corrupt system ROM.
HP ROM provides for essential initialization and validation of hardware components before control is
passed to the customer-installed operating system. The ROM also provides the capability of booting from
various fixed media (HDD, CD-ROM) and removable media (USB), to continue operation to the operating
system.
HP ROM performs very early configuration of the video controller, to allow monitoring of initialization
progress via an attached monitor. If configuration or hardware errors are discovered during this early
phase of hardware initialization, suitable messages are now displayed on the connected monitor.
Additionally, these configuration or hardware errors are logged to the Integrated Management Log (IML) to
assist in diagnosis.
HP's ProLiant ROM is used to configure the following:
Processor and chipset status registers
System memory, memory map, and memory initialization
System hardware configuration (Integrated PCI devices and optional PCIe cards).
Customer-specific BIOS configuration (using the HP ROM-Based Setup Utility (RBSU).
NOTE:
For further information, please refer to HP's RBSU (ROM based setup utility) user guide:
www.hp.com/support/rbsu
.
Storage Controller
HP Dynamic Smart Array B120i Controller
NOTE:
Supports up to 6.0Gb/s SATA. (SATA port 0/1 support 6Gb/s and SATA port 2/3 support 3Gb/s)
NOTE:
Supports RAID 0/1/10 only. No FBWC support. For FBWC, a standup Smart Array Controller card
must be configured.
NOTE:
For set up instructions, please refer to the HP ProLiant ML300 series server user guide.
NOTE:
For general information about HP Smart Array B120i SATA RAID Controller, please go to:
http://h18004.www1.hp.com/products/servers/proliantstorage/arraycontrollers/smartarrayb120i/
index.html
Internal Storage Devices
Optical Drives
One of the following
depending on model
HP Half-Height SATA DVD-ROM Optical Drive
HP Half-Height SATA DVD-RW Optical Drive
Hard Drives
1x500GB HP LFF SATA HDD included in Performance Model
Hard Drive Bays
One of the following
depending on model
4 LFF drive bays (non-hot-plug and hot-plug)
8 SFF hot-plug drive bays
NOTE:
HP ProLiant ML310e Series servers offer both SFF, and LFF versions in
CTO.
NOTE:
All Pre-configured Models come populated with some hard drive blanks
installed. Should the customer need additional hard drive blanks, they can
order more using either P/N 666987-B21: HP SFF Gen8 Hard Drive Blank Kit or
P/N 666986-B21: HP LFF Gen8 Hard Drive Blank Kit.
QuickSpecs
HP ProLiant ML310e Generation 8 (Gen8) v2
Standard Features
DA - 14564 Worldwide — Version 11 — December 13, 2013
Page 4
To Next Page
Loading...
Need help?
General
Weight and Dimensions
