Hood sensor
The hood sensor is located to the right of the system board.
To remove the hood sensor:
1. Prepare the computer for disassembly (see Preparing to disassemble the computer on page 19).
2. Remove the stand (see Stand on page 19).
3. Remove the rear port cover (see Rear port cover on page 24).
4. Disconnect the hood sensor cable from the system board (1).
5. Remove the cable from the clips in the computer (2).
6. Pry the sensor out of the slot to remove it (3).
To install the hood sensor, reverse the removal procedures.
Hood sensor 35
To Next Page
Loading...
