7. Lift the stand up and off the computer.
Figure 2-15 Removing the stand
Installing and removing a tilt/swivel stand (optional)
Installing a tilt/swivel stand
To install the stand:
1. Place the computer face down on a soft flat surface. HP recommends that you set down a blanket,
towel, or other soft cloth to protect the bezel and screen surface from scratches or other damage.
2. Push the release button on the bottom of the stand and pull the back of the stand off.
3. Engage the hooks in the top of the stand in the two large holes in the top of the lower panel, and
lower the stand onto the computer.
Figure 2-16 Installing the stand
Installing and removing a stand
21
To Next Page
Loading...
