3. With the 3.5-inch hard disc drive connector facing toward the center of the chassis, place the
hard disc drive cage into the chassis and slide it toward the center until it snaps into place.
Figure 2-44 Installing the 3.5-inch hard disc drive cage
4. To replace the access panel, set the panel on the back of the computer, slightly above the stand,
and slide it down into place.
Figure 2-45 Replacing the access panel
5. Reconnect the power cord and external devices.
6. Lock any security devices that were disengaged when the access panel was removed.
7. Place the computer in the upright position.
8. Turn on the computer.
Replacing drives
41
To Next Page
Loading...
