To Next Page

To Previous Page

Remove the rear-facing webcamera (2) and cable.

Reverse this procedure to install the rear-facing webcamera.

WiFi antenna board

Description Spare part number

WiFi antenna board (includes RF antenna cable and double-sided adhesive) 751315-001

Before removing the WiFi antenna board, follow these steps:

1. Turn off the tablet. If you are unsure whether the tablet is off or in Hibernation, turn the tablet on,

and then shut it down through the operating system.

2. Disconnect the power from the tablet by unplugging the power cord from the tablet.

3. Disconnect all external devices from the tablet.

4. Remove the back cover (see

Back cover on page 12).

5. Remove the middle frame (see

Middle frame on page 14).

Remove the WiFi antenna board:

1. Disconnect the WiFi antenna board cable from the system board wireless terminal (1).

2. Release the WiFi antenna board cable from the routing channel (2) between the battery and

the system board.

18 Chapter 5 Removal and replacement procedures

Questions and Answers:

Need help?

Do you have a question about the HP Slate7 VoiceTab and is the answer not in the manual?

HP Slate7 VoiceTab Specifications

General